Procedure command or action purpose step 1 ucs a show cluster state displays the state of fabric interconnects in the cluster and whether the.
Ucs fabric interconnect commands.
In our introduction to cisco ucs architecture we touched briefly on the cisco ucs fabric interconnect specifically we talked about the latest generation the cisco ucs 6454 fabric interconnect.
However in the ucs fi cli guide there is no mention of this command.
Ucs a scope fabric interconnect a ucs a fabric interconnect activate firmware kernel version 3 0 ucs a fabric interconnect commit buffer ucs a fabric interconnect related commands.
Connect to the console port of fabric interconnect 1 which will be the primary member in the cluster.
Following on from cabling our cisco ucs infrastructure we will first begin to configure the fabric interconnects using the basic system configuration dialog.
Power on this fabric interconnect leaving the secondary interconnect powered off for now.
When committed this change may disconnect the current cli session ucs a fabric interconnect commit buffer enabling a standalone fabric interconnect for cluster configuration.
From there i could have run connect local mgmt b and accessed ucsm which was running just fine on fabric interconnect b and flipped ucsm back to fabric interconnect a using local mgmt commands.
The success in doing that would have instantly led me to the mgmt0 connection on the b fabric.
Found that from ucs fabric interconnect there is a command to connect to nxos.
The following example shows how to activate a specific version of kernel software on fabric interconnect a.
After connecting to nxos some no of show nxos cli commands available on nexus 5x series are available but no conf t works.
You must force the failover from the primary fabric interconnect.
Well i could always access the a fabric interconnect.